Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 176)

 

8-6 Document: 553633
ICSTT-RM405f-EN-P
Issue 07
Configuration Guide (AADvance Controller)
Configure an AADvance Variable as a Producer
When you configure a variable as a producer for CIP over Ethernet/IP do the
following:
1) Go to the Dictionary and select a CIP produce variable that you have previously
defined in the dictionary.
2) Make sure that the variable is a type that supports CIP over Ethernet/IP.
3) Open the variable properties dialog box and select the CIP tab.
4) Select Producer from the drop-down list.
5) Set the Maximum number of connections to the maximum number of
simultaneous consumers allowable for this variable.
6) Click OK.
The configuration of the variable as a producer is now complete.
Defining The AADvance Controller as a CIP Producer
Within the RSLogix5000 CLX configuration it is necessary to configure an
AADvance controller as a CIP provider. Presently this is performed in the I/O
Configuration Tree, do the following:
1) Expand the relevant CLX Ethernet I/P Module to display the Ethernet Network
Tree.
2) Insert a new module.