Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 77)

 
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
4-37
1) Select the Variables tab of the 9110 Processor Editor.

The 9110 Variables Editor dialog box opens.
2) Select a rack, e.g. Status Registers.

The editor displays a list of associated channel variables.
3) Select a Channel.
4) Click the button. The Select Variable dialog box opens.
5) From the list select an application variable to wire to the processor variable, click
OK.
6) Repeat for each subsequent variable to be wired.
7) Return to the 9110 Processor Editor dialog box and click Apply. The variable
will now be wired.
Unwire Processor Variables
To disconnect a 9110 processor variable do the following:
1) Select the Variables tab of the 9110 Processor Editor.

The 9110 Variables Editor will be displayed.
2) Select the relevant rack.

The editor displays a list of associated variables.
3) Select the variable to be unwired, click the X button.
4) Click Apply.

The variable will be unwired.
Note: Select the Unwire All button and click Apply to disconnect all of the wired
variables in the rack.