Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 250)

 

11-2 Document: 553633
ICSTT-RM405f-EN-P
Issue 07
Configuration Guide (AADvance Controller)
Peer to Peer Configuration Process
Configuring the AADvance controller to communicate with a Trusted Peer to Peer
network requires the same parameters as a Trusted configuration. The configuration
for AADvance is arranged in a tree in the I/O Configuration view. The recommended
process for setting up a peer to peer network is as follows:
 Create a peer to peer network and give it an identity
 Select a peer to peer subnet configuration and enter the subnet data
 Enter the peer IP Address information
 Configure the I/O boards
 Wire the I/O board status parameters to variables
 Wire the I/O board channel data to variables
Create a Peer to Peer Network
Create a peer to peer network as follows:
1) Select the Equipment tab.
2) Right click on the Config (9000 Series Controller).
3) Select the Peer to Peer option and any network option, in this case Network 4
has been selected.

A peer network Network 4 is set up.
4) Enter the peer identity number in the Peer ID field.