Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 159)

 
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
6-5
Configure the IP Address of the Target Controller
To connect the AADvance Workbench project to the target controller you have to
tell the project the IP addresses allocated to the controller. Do the following:
1) Select the Hardware Architecture view then double-click on the vertical
connection between the SNCP network line and the configuration.
2) The Connection - Properties dialog box opens.
3) Enter the IP Addresses in the Value field for each of the required Ethernet
network. Press Enter after typing each IP address.
Note: The value shown above is a default value. Enter a value that you require.
4) Click OK.