Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 219)

 
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
9-33
Description Value(s) Default Remarks
Reporting Mode Disabled;
Last Rate;
Maximum Rate:
Average Rate
Disabled Sets the application statistic to
report
Data Variable
Address 1 to 65,536,
or 0 to disable 0 Data variable is reported in
hundredths of a second
Reset Variable
Address
1 to 65,536,
or 0 to disable
0 Write any non-zero value to the
reset variable to reset the data
variable to zero
Create Links to Modbus Slaves
A slave link represents the connection between a Modbus master object and a server.
The AADvance Workbench represents each slave link by a slave object, one object for
each server.
Note: If you have configured the master object for Modbus TCP (with Ethernet
communications), create only one slave link for the master object.
To create a slave link, do the following:
1) Select the Equipment tab on the Project tree view and locate the Modbus master
object to which you will add the slave link.
2) Right-click on the Modbus master object and select Add Slave.

A slave link object is inserted below the Modbus master object.

A default name is allocated to the object; the name includes the number of the
processor module and the number of the master, with a serial number for the
slave object. You can change the name when you configure the object.
3) Create additional slave links as needed, one for each Modbus slave device.

You can now configure the Modbus slave link objects.
Note: If you create multiple slave links for a Modbus RTU master and then
choose to reconfigure the master for Modbus TCP, you must keep one slave link
and delete all of the others. Right-click on each unwanted slave link in turn and
select Remove Slave.