Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 267)

 
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
11-19
Peer-to-Peer Controller Setting Summary
You should follow the process described in this chapter.
The network configuration is as follows:
 16 analogue outputs are sent from Controller 1 to Controller 2
 16 analogue values are sent form controller 1 to Controller 3
 16 digital values are sent from Controller 2 to controller 4
Table 37: Controller 1 - Dual Peer-to-Peer Net Control, Network 1, Subnet 1
Value Comment
DXPNC40
Network Interface A Network connected to processor A
Network Identity 1 Network 1
Subnet Identity 1 Subnet 1
Peer ID 1 Identity of this controller
Response Timeout 0 Default
Refresh Timeout 2000 Default
Slave Transmit timeout 500 Default
Enable Controller TRUE Enable Peer on this subnet
Master/Slave FALSE This is a slave connection
Peer List
Peer 1 10.10.1.1 Controller 1, network 1, subnet 1
Peer 2 10.10.1.2 Controller 2, network 1, subnet 1
Peer 3 10.10.1.3 Controller 3, network 1, subnet 1
Peer 4 10.10.1.4 Controller 4, network 1, subnet 1
Peer 5
Peer 6
Peer 7
Table 38: Controller 1 - Dual Peer-to-Peer Net control, network 1 subnet 2
Value Comment
DXPNC40
Network Interface B Network connected to processor B
Network Identity 1 Network 1
Subnet Identity 2 Subnet 1