Westermo MR Series - Manual (Page 160)

160 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Interface must use this APN:
This parameter allows you to choose between using the main APN or the backup APN, as
defined in the Configure > GPRS Module page
Use Secondary IP address:
When this parameter is set to “ON”, tunnels set up from this eroute will use the IP address set
in the Secondary IP address parameter on the Configure > General page as the source address
for tunnelled packets. This gives the unit the ability to set two tunnels up to a single remote
peer, and appear as though it is two separate units. Use in conjunction with This eroute is tun-
nelled within another eroute.
Delete SAs when eroute goes out of service:
When this parameter is set to “Yes”, and the Eroute goes out of service, any SAs associated
with the Eroute will be deleted.
Inhibit this eroute when these eroutes are not OOS:
This is a list of eroute numbers that will inhibit this eroute from being used as long as they are
not OOS. If the eroute has been allowed to operate, and the eroute that inhibits it comes back
into service, any SAs that may have existed are removed. As soon as an inhibiting eroute goes
OOS, the unit will check to see if the inhibited eroute can now create SAs.
Inhibit unless this eroute is UP:
If this parameter is used, this eroute will only become active when the eroute specified is also
active.
Delete SAs if not VRRP Master:
When this parameter is set to “Yes”, at least one Ethernet instance must be set as VRRP Master
before the unit can create SAs. If the unit switches away from VRRP Master state, SAs will be
deleted. When the unit switches back to VRRP Master state, SAs will be created automatically.