Westermo MR Series - Manual (Page 354)

354 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
C1
The cell selection criterion.
Dedicated channel parameters:
chann
The ARFCN of the Traffic Channel (TCH) carrier. The TCH is the bi-directional channel used for
speech or circuit switched data. A value of “h” indicates frequency hopping.
TS
Timeslot number.
timAdv
The timing advance in bits.
PWR
Current power level.
DBm
The receiving level of the traffic channel carrier in dBm.
Q
The receiving quality (0-7).
ChMod
The channel mode (S_HR = half rate, S_FR = full rate, S_EFR =enhanced full rate).
Additional Text
Additional text is provided to indicate the state of W-WAN module.
No Connection
The W-WAN module is camping on a cell and registered to the network. The service state is
“idle”,
i.e. there is no dedicated channel in use or connection established. This is normally the state
seen when using W-WAN.
Limited Service
The W-WAN module is camping on a cell but not registered to the network. Only emergency
calls are allowed. This state typically occurs when there is no SIM inserted, or a required PIN
has not been provided. Other reasons for this state are:
Neither home PLMN nor any other allowed PLMN found. •
Registration request was not answered or was denied by the network (see the Network •
Registration parameter on the Status > W-WAN Module web page).
Authentication failed.
•
Cell Reselection
The W-WAN module has not yet lost coverage but is searching for a better cell, since the cell
reselection criterion has been fulfilled.
Searching
The W-WAN module is searching, but could not yet find a suitable cell. You might see this state
immediately after power-up or after loss of coverage.