Westermo MR Series - Manual (Page 423)

423 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
S31 Port Speed (bps) S31 Port Speed (bps)
0 Auto-detect 6 19,200
1 Reserved 7 9,600
2 Reserved 8 4,800
3 115,200 9 2,400
4 57,600 10 1,200
5 38,400 11 300
For example, to change the speed of ASY 1 to 38,400bps, connect your terminal to that port with
the speed set to 9600bps. Enter the command:
ats31=5
then change the speed of your terminal to 38,400bps before entering any more AT commands.
The data format used when the ATS31=n command is entered is selected as the data format for all
further commands.
The auto-detect option is only available for ASY0 and ASY1.
S33 DTR Dialling 18.8
Units: N/A
Default: 0
Range: 0, 1
S33 is used to enable or disable DTR dialling for the port. When DTR dialling is enabled, the unit
will dial the number stored for that port (see AT&Z) when the DTR signal from the terminal chang-
es from Off to On.
S45 DTR Loss De-Bounce 18.9
Units: 0.05 seconds
Default: 5
Range: 1-255
The value in S45 determines the length of time for which the DTR signal from the terminal device
must go off before the unit acts upon any options that are set to trigger on loss of DTR. Increasing
or decreasing the value in S45 makes the unit less or more sensitive to “bouncing” of the DTR sig-
nal respectively.
The application commands described in this section are basic configuration commands that do not
relate to specific types of application or network.