Westermo MR Series - Manual (Page 90)

90 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the eth command to configure or display the Ethernet interface set-
tings. To display the current settings for the Ethernet interface enter the following command:
eth <instance> ?
where <instance> is the number of the Ethernet interface.
To change the value of a parameter use the following command:
eth <instance> <parameter> <value>
The parameters and values are:
Parameter Values Equivalent Web Parameter
descr text Description
dhcpcli off, on DHCP client
dnsserver IP address DNS server
do_nat 0,1,2 NAT mode: 0=Off
1=NAT
2=NAPT
ethanon 0-3 Analyser: Ethernet sources
firewall off, on Firewall
fulldup off, on Full duplex
gateway IP address Gateway
gre off, on GRE
group 0-3, 255 Group
hbimsi off, on Heartbeat includes IMSI:
hbroute off, on Heartbeat selects interface from
routing table
heartbeatint number Heartbeat request interval (s)
heartbeatip IP address Heartbeat IP address
igmp off, on IGMP
ip2count number PING IP switchover count
ipaddr IP address IP address
ipanon off, on Analyser: IP sources
ipsec 0,1 IPSec: 0=Off 1=On
ipsecadd number IPSec source IP from interface #
ipsecent blank, PPP, ETH IPSec source IP from interface
linkdeact number Physical link down deact delay
macfilt off, on MAC address filtering
mask IP netmask Mask
maxkbps number Max Rx rate (kbps)
maxtkbps number Max Tx rate (kbps)
mhome number Multihome additional consecutive
addresses
mtu number MTU
nocfg 0,1,2,3 Remote management:
0=No restrictions
1=Disable management
2=Disable return RST
3=Disable management and return
RST
oossecs number Out of service time (s)
pingint number PING request interval (s)