Westermo MR Series - Manual (Page 239)

239 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the snmptrap command to configure or display SNMP Trap server set-
tings.
To display current settings for an SNMP instance enter the following command:
snmptrap <instance> ?
where <instance> is 0-1.
To change the value of a parameter use the following command:
snmptrap 0 <parameter> <value>
The parameters and values are:
Parameter Values Equivalent Web Parameter
ipaddr IP address Trap Server IP Address
port number Trap Server Port
version v1, v2c, v3 Snmp Version
community text Community
engineid alpha-numeric text Trap Server Engine ID
securityname text Trap Server Security Name
securitylevel noauthnopriv
authnopriv
authpriv Trap Server Security Level
For example, to set trap server 0 to IP address 192.168.0.100 enter:
snmptrap 0 ipaddr 192.168.0.100