Westermo MR Series - Manual (Page 65)

65 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Confi gure > Calling Numbers 4.14
Note:
This feature is for use by experienced personnel for network testing and fault diagnosis. It
should not be required in normal use. To use this feature, your ISDN circuit must support the
Calling Line Identi fication (CLI) facility. If CLI is available, incoming calls from specified numbers
may be answered nor mally or alternatively, rejected with an optional reject code.
Using the Web Page(s)
The Configure > Calling Numbers page contains a table that allows you to enter a series of tele-
phone numbers each of which has an associated Answer or Reject parameter, and in the case of
num bers from which calls are to be rejected, a user defined reason code. For each number that
you enter and set to “Reject”, the unit will reject incoming calls from that number using the reject
reason code specified. The reason code is simply a numeric value that may be selected to suit your
particular appli cation. If any one of the entries is set to “Answer” the unit will only answer incoming
calls from that number and will reject calls from other numbers using a standard ISDN reject code.
Using Text Commands
To configure calling numbers from the command line use the rejlst command. To display an entry in
the calling numbers list enter the command:
rejlst <entry> ?
where <entry> is 0-9.
For example, to display entry number 5 enter the command:
rejlst 5 ?
Up to three separate commands are needed to set up an entry. These take the form:
rejlst <entry> NUM <number>
rejlst <entry> ANS <mode>
rejlst <entry> CODE <code>
where: <entry> is the required entry number in the calling numbers table in each case.
<number> is the telephone number.
<mode> is either Off to reject calls from the corresponding number (the default), or On to accept
calls.
<code> is the reject reason code.
For example:
rejlst 0 NUM 1234567
rejlst 0 ANS OFF
rejlst 0 CODE 42