Westermo MR Series - Manual (Page 161)

161 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the eroute command to configure or display Eroute settings. To display
current settings for a specific Eroute, enter the command:
eroute <eroute> ?
where <eroute> is the number of the eroute.
To change the value of a parameter use the command in the format:
eroute <eroute> <parameter> <value>
The parameters and values are:
Parameter Values Equivalent Web Parameter
ahauth off, md5, sha1 AH authentication algorithm
apnbu 0,1 Interface must use this APN: 0=Main APN
1=Backup APN
authmeth off, preshared, rsa Authentication method
autosa off, on Create SA’s automatically
bakpeerip ip address Backup peer IP address.
check_apnbu off, on Check APN usage
dhgroup 0,1,2,3 IPSec MODP group
enckeybits number ESP encrypt key length (bits)
espauth off, md5, sha1 ESP authentication algorithm
espenc off, des, 3des, aes ESP encryption algorithm
gre off, on GRE
idisfqdn no, yes Send our ID as FQDN
ifadd number Link eroute with interface #
ifent blank, ppp, eth Link eroute with interface
ifvrrpmaster off, on Delete SAs if not VRRP Master
ikecfg 0,1 IKE config to use when initiator
ikever 1,2 IKE version
inhibitno numbers Inhibit this eroute when these eroutes are not
OOS
Parameter Values Equivalent Web Parameter
intunnel off, on This eroute is tunnelled within another eroute
ipcompalg off, deflate IPCOMP algorithm
lkbytes number Duration (kb)
locfirstport 0-65535 First local port (IKEv2 only)
locip IP address Local subnet IP address
locipifadd blank, ppp, eth Interface to use for local subnet IP address
locipifent number Interface # to use for local subnet IP address
loclastport 0-65535 Last local port (IKEv2 only)
locmsk IP netmask Local subnet mask
locport number Local port
ltime 0-28800 Duration (s)
mode tunnel, transport Mode
natkaint number NAT keep alive interval (s)
neglocip IP address Local subnet IP address to negoti ate (if different
from above)