Westermo MR Series - Manual (Page 96)

96 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Probe priority adjustment direction:
This parameter specifies the direction in which the Group priority will be adjusted in the event
that the Probe failure limit is reached.
Probe failure priority adjustment:
This parameter is used to set the amount of priority adjustment applied to the Group priority
in the event that the Probe failure limit is reached.
Probe interface: & Probe interface #:
These parameters are used to specify the port to be used for the VRRP probing. If set to Auto,
the routing table will be used to decide which port to send the packets out of.
Using Text Commands
From the command line, use the eth command to configure or display the Ethernet interface VRRP
settings.
To display current settings enter the following command:
eth <instance> ?
where <instance> is the number of the Ethernet interface.
To change the value of a parameter use the following command:
eth <instance> <parameter> <value>
The parameters and values are:
Parameter Values Equivalent Web Parameter
vprobeadd number Probe interface #
vprobeadj 0-255 Probe failure priority adjustment
vprobeadjup 0,1 Probe priority adjustment direction:
0=Down 1=Up
vprobebackint 0-32767 Backup state probe interval (s)
vprobeent Auto, Eth, PPP Probe interface
vprobefailcnt 0-255 Probe failure limit
vprobeip IP address Probe IP address
vprobemastint 0-32767 Master state probe interval (s)
vprobemode Off, ICMP, TCP Probe mode
vprobeport Port number Probe port
vprobesuccesscnt 0-255 Consecutive probe successes
required
For example, to turn VRRP probing on in TCP mode for Ethernet port 0 enter:
eth 0 vprobemode tcp