Westermo MR Series - Manual (Page 202)

202 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Confi gure > PPP > PPP n > QOS 4.63
In addition to the QOS parameter on the PPP N standard parameters pages (which are used to
enable quality of service management for that PPP instance), each PPP instance has an associated
QOS instance (PPP 0 maps to QOS 0, PPP 1 maps to QOS 1, etc.). These QOS instances include
10 QOS queues into which packets may be placed when using QOS. Each of these queues must be
assigned a queue profile (from the twelve available profiles defined in the Configure > Quality of
Service > Q Profile pages), and a priority value.
Using the Web Page(s)
Each PPP n > QOS page includes the Link speed parameter at the top followed by a list of queues
with drop-down selection boxes that are used to assign a profile and a priority to each queue.
Link speed (Kbps):
This parameter should be set to the maximum data rate that this PPP link is capable of sustaining. It
is used when calculating whether or not the data rate from a queue may exceed its Minimum Kbps
setting (as determined by the profile assigned to it) and send at a higher rate (up to the Max imum
Kbps setting).
Queue priorities:
Below this heading is a list of the queues from 0 to 9 alongside each of which are drop down selec-
tion lists for assigning profile numbers (from 0 to 11) and queue priorities. The priority may be set
to “Very High”, “High”, “Medium”, “Low” or “Very Low”.