Westermo MR Series - Manual (Page 83)

83 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Update interval (days):
Specifies the number of days between Dynamic DNS updates.
Update only when VRRP Master:
When this parameter is set to “ON”, at least one Ethernet port must be a VRRP master before
the unit will perform a Dynamic DNS update.
Using Text Commands
From the command line, use the dyndns command to configure or display DNS Update settings. To
display current settings enter the command:
dyndns <instance> ?
where <instance> is 0.
To change the value of a parameter use the command in the format:
dyndns <instance> <parameter> <value>
where <instance> is 0. The parameters and values are:
Parameter Values Equivalent Web Parameter
epassword text None - this is the password in
encrypted format. This parameter is
not configurable.
hostname1 text Hostname 1
hostname2 text Hostname 2
hostname3 text Hostname 3
hostname4 text Hostname 4
hostname5 text Hostname 5
ifadd number Interface #
ifent none, ppp, eth, default Interface
ifvrrpmaster off, on Update only when VRRP Master
noip off, on Supply address in update
password text Password
system 0,1,2 System
username text Username
updateint number Update interval (days)
wildcard 0,1 2 Wildcards: 0=Off 1=On 2=No
Change
For example, to set the username to “david24” you would enter the command:
dyndns 0 username david24