Westermo MR Series - Manual (Page 99)

99 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the vlan command to configure or display the VLAN instance. To dis-
play the current settings for the VLAN instance enter the following command:
vlan <instance> ?
where <instance> is the VLAN instance (0 - 9).
To change the value of a parameter use the following command:
vlan <instance> <parameter> <value>
The parameters and values are:
Parameter Values Equivalent Web Parameter
ethctx number ETH Instance
ipaddr IP address IP Address
mask IP netmask Mask
srcipaddr IP address Src IP Address
srcmask IP netmask Src Mask
vlanid number VLAN Id
For example, to set the IP Address to 212.154.30.16 for VLAN 2, you would enter:
vlan 2 vlanid ipaddr 212.154.30.16