Westermo MR Series - Manual (Page 357)

357 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Status > IGMP Groups 6.13
The Status > IGMP Groups lists statistics relating to the Internet Group Management Protocol
(IGMP). This protocol is used for the management of IP multicast group membership. The statistics
are described in the following table:
Abbreviation Description
Free Groups Number of available multicast group entries
Min Free Groups Lowest value of Free Groups since power up
RX Total Total number of IGMP packets received
RX Reports Number of host membership report packets received
RX Queries Number of host membership query packets received
TX General Queries Number of general group membership query packets transmitted
TX Group Queries Number of group specific membership query packets transmitted
Too Short Number of IGMP packets received with an incorrect length
Bad Checksum Number of IGMP packets received with an incorrect checksum
RX Bad Queries Number of bad query packets received
RX Bad Reports Number of bad report packets received
Status > IPSec > IPSec Peers 6.14
The Status > IPSec > IPSec Peers page shows details for each IPSec peer.
Peer IP
The IP address of the remote unit.
Peer ID
The ID of the remote unit.
DPD
This field displays DPD status and the time until the next DPD request.
NATT local port
The local NATT port.
NATT remote port
The remote NATT port.