HEIDENHAIN CNC Pilot 4290 - Manual (Page 11)

Contents
HEIDENHAIN CNC PILOT 4290
VII
6.12 Interactive Working Plan Generation (IWG)..... 286
6.12.1 Tool call..... 287
6.12.2 Cutting Data..... 288
6.12.3 Cycle specification..... 288
6.12.4 Roughing..... 289
6.12.5 Recessing..... 294
6.12.6 Drilling..... 299
6.12.7 Finishing..... 301
6.12.8 Thread Machining(G31)..... 306
6.12.9 Milling..... 307
6.12.10 Special Machining Tasks (SM)..... 309
6.13 Automatic Working Plan Generation (AWG)..... 310
6.13.1 Generating a Machining Plan..... 310
6.13.2 Machining Sequence..... 311
6.14 Control Graphics..... 321
6.15 Configuration..... 322
6.16 Machining Information..... 324
6.16.1 Tool Selection, Turret Assignment..... 324
6.16.2 Cutting Parameters..... 325
6.16.3 Coolant..... 325
6.16.4 Hollowing..... 326
6.16.5 Inside Contours..... 326
6.16.6 Drilling..... 328
6.16.7 Full-Surface Machining..... 328
6.16.9 Shaft Machining..... 330
6.17 Example..... 332
7 Parameters..... 337
7.1 Parameter Mode of Operation..... 338
7.1.1 Parameters..... 338
7.1.2 Editing Parameters..... 339
7.2 Machine Parameters..... 341
7.3 Control Parameters..... 348
7.4 Set-Up Parameters..... 355
7.5 Machining Parameters..... 357