HEIDENHAIN CNC Pilot 4290 - Manual (Page 446)

11 Tables and overviews 434
11
.2
T
e
c
hnical
Inf
or
mation
Programming CNC PILOT 4290
DIN editor Programming in DIN 66025 (ISO 6983) format
DIN PLUS ■ Setup information on workpiece blank, material, tools, chucking
equipment
■ Expanded command set (IF...THEN...ELSE;WHILE...; SWITCH...CASE)
■ Dialog-guided input an help graphics for every programming function
■ Subprograms and variable programming
■ Control graphics for workpiece blanks and finished parts
■ Parallel programming
■ Parallel simulation
■ alphanumeric program name
Cycles for contour description ■ Standard workpiece blank forms
■ Recesses
■ Undercuts
■ Thread
■ Hole pattern for the front face and lateral surface (XY and ZY plane)
■ Figure pattern for the front face and lateral surface (XY and ZY plane)
Fixed cycles ■ Area clearance longitudinal and transverse
■ Recessing cycles radial and axial
■ Recess turning cycles radial and axial
■ Undercut cycles
■ Parting cycles
■ Thread cycles radial and axial (multiple threads, successive threads,
taper threads, variable pitch)
■ Drilling, deep-hole drilling, and tapping cycles (conventional/rigid) radial
and axial (C axis and Y axis)
■ Contour milling and pocket milling radial and axial (C axis and Y axis)
■ Area milling, centric polygon milling radial and axial (Y axis)
TURN PLUS – graphic programming (option)
Geometrical workpiece description for workpiece blank and finished part
Graphical geometry program for calculation and display of any length of a
series of dimensioned or also nondimensioned contour points
■ÿ With simple input of standard form elements:
Chamfer, rounding radii, undercuts, recesses, thread, fits
■ With simple input of transformations:
Shifting, rotating, mirroring, multiplying
■ If more than one geometrical solution exists for calculated coordinates
all of them are presented for selection.