HEIDENHAIN CNC Pilot 4290 - Manual (Page 68)

3 Manual Control and Automatic mode 56
3.7 Load Monit
or
ing
3.7.3 Editing Limit Values
The function for editing the load parameters allows
you to analyze reference machining cycles and
optimize limit values.
The CNC PILOT displays the program name of the
loaded monitoring parameters in the header.
Selection: ”Display – Load monitoring – Edit”
(Automatic mode).
”Load parameter editor” submenu
■ ”Act. load” (Load current file) menu item:
Monitoring parameters of the active NC program.
■ ”Load” menu item: Monitoring parameters you
have selected.
■ ”Edit” menu item: Display and edit the limit
values.
■ ”Delete reference values” menu item: Delete the
load parameters of the NC program.
■ Auto Returns to the automatic menu
Editing the load parameters
The ”Display and adjust load parameters” dialog box
displays the parameters of one component of one
monitoring zone, which can then be edited.
The bar graphic shows all components of the
monitoring zone (the larger bar displays the values for
performance; the smaller bar displays the values for
work). The selected component is highlighted.
Enter the monitoring zone and select the component.
The CNC PILOT displays the reference values. The
limit values for performance and work, which are
displayed, can be edited. The tool (T number) is
displayed for information.
Buttons of the dialog box:
■ Saving: Store the limit values of the component in
the specified zone.
■ End (or ESC key): Exit the dialog box.
■ File: Switch to ”Line graphics.” Precondition: The
values measured during the reference machining
cycle have been stored.