HEIDENHAIN CNC Pilot 4290 - Manual (Page 286)

6 TURN PLUS 274
6.1
0 Oper
ating
Aids
6.10.2 Digitizing
Input values can be determined and transferred to the
input field using the quadruple arrow (digitizing). TURN
PLUS displays the coordinates of the cross-hairs
position.
Activate digitizing mode (with opened
dialog box)
Position the cross hairs: Cursor keys or mouse
Exit digitizing mode:
■ ”Enter” – with value transfer
■ ”ESC” – without value transfer
■ Change the zoom setting before calling
the digitizing mode if the increments of the
cross hairs movements are too small/
large.
■ The values are taken over as absolute
values of the Cartesian coordinate system
– independent from the setting of the input
fields.
6.10.3 Inspector – Checking Contour
Elements
The ”inspector function” can be used to check
contour elements, form elements, figures and
patterns. It is not possible to edit the displayed data.
Checking contour elements with the inspector
function:
Select the desired window (reference plane).
Call the ”inspector”
Position the cursor on the contour/form element,
figure or pattern and confirm
TURN PLUS shows the entered parameters
ALT key: TURN PLUS shows all parameters of the
element – for form elements the parameters of the
individual elements
Arrow left/right (with opened dialog box): Shows
the parameters of the following/previous element
To close the dialog box, press the ESC key.