HEIDENHAIN CNC Pilot 4290 - Manual (Page 93)

HEIDENHAIN CNC PILOT 4290 81
4.4 Pr
ogr
am Section Codes
Example: TURRET -- Table
REVOLVER 1 [TURRET]
T1 ID”342-300.1” [Tool from the database]
T2 WT1 X50 Z50 R0.2 B6 [simple tool description]
T3 WT122 X15 Z150 H0 V4 R0.4 A93 C55 I9 K70 [extended
tool description – not transferred to database]
T4 ID”Erw.1” WT112 X20 Z150 H2 V4 R0.8 A95 C80 B9 K70
[extended tool description – with transfer to database]
. . .
n Extended input:
n No constraints for the use of the tool.
n Only the tool tip is shown in the simulation.
n First you define the tool type, then you edit the tool parameters.
The tool parameters are shown in the parameters of the first dialog
box to the tool editor (see ”
8.1 Tool Database).
n The data are saved in the database during program compilation
only if you enter the ID number.
n Simple tool:
n Only suitable for simple traverse paths and turning cycles
(G0...G3, G12, G13; G81...G88).
n No contour regeneration.
n Tooth/cutter radius compensation.
n Simple tools are not included in the database.
n For the meaning of the parameters, refer to the table below.
Simple tools
Dialog box NC program Meaning
Tool type WT Tool type and machining direction
X dimension (xe) X Setup dimension
Y dimension (ye) Y Setup dimension
Z dimension (ze) Z Setup dimension
Radius R (rs) R Cutting radius of turning tools
Cutting width B (sb) B Cutting width of recessing and
button tools
Diameter I (df)
I Milling or drilling diameter
■ If you do not program the TURRET,
the tools entered in the ”tool list” are used
(see ”
3.3.1 Setting Up the Tool List”).
■ The names ”_SIM...” and ”_AUTO...”
are reserved for temporary tools (simple
tools and tools without ID number). Tool
entries are valid as long as the NC pro-
gram is activated in the simulation or
Automatic mode.