HEIDENHAIN CNC Pilot 4290 - Manual (Page 65)

HEIDENHAIN CNC PILOT 4290 53
Cycle status (slide display)
Automatic mode – Cycle Start
Automatic mode – Feed Stop
Automatic mode – Cycle Stop
Manual control
Inspection cycle
Machine in setup mode
Spindle status (spindle display)
Direction of spindle rotation M3
Direction of spindle rotation M4
Spindle stopped
Spindle position-controlled (M19)
C-axis is ”active”
Display elements (continued)
Quantity of workpieces/time per workpiece
■ Number of finished workpieces in this batch
■ Machining time of current workpiece
■ Entire production time of this batch
Load display
Load of the spindle motors/axis drives with regard to rated torque
D display – additive compensation
■ Number of the active compensation
■ Compensation values
Slide display
■ White symbol: No enabling
■ Number: Selected slides
■ Cycle state: see table
■ Bar diagram: Feed rate override ”in %”
■ Upper box: Feed rate override
■ Lower box: Current feed rate – with stationary spindle: Nominal
feed rate (gray print)
■ Slide number in blue background: Rear side machining active
Spindle display
■ White symbol: No enabling
■ Number in spindle symbol: Gear range
■ ”H”/number: Selected spindle
■ Spindle status: See table
■ Bar diagram: Spindle speed override ”in %”
■ Upper box: Spindle speed override
■ Lower box: Current speed – with position control (M19): Spindle
position – with stationary spindle: Nominal speed (gray print)
Overview of enabled elements
Shows the enabling status of up to 6 NC channels, 4 spindles, and 2
C-axes. Enabled elements are marked in green.
■ Display group at left: Enabled elements
F=feed rate; D=data; S=spindle; C=C-axis.
1..6: Number of slides/ of spindle, of C axis
■ Display group at center: Status
Zy – left dash: Cycle on/off.
Zy – right dash: Feed Stop.
R=traversing the reference marks; A=automatic mode;
H=manual control;
F=retracting (after traversing the limit switches);
I = Inspection mode; E = Setup switch;
■ Display group at right: Spindle
Display for ”direction of rotation left/right.”
Both active: Positioning of spindle (M19).
3.6 Machine Display