HEIDENHAIN CNC Pilot 4290 - Manual (Page 304)

6 TURN PLUS 292
Residual roughing (hollowing) – contour parallel
Parameters
P:
Cutting depth (maximum infeed)
A: Approach angle (reference: Z axis)
■ Longitudinal: Default 0°/180° (parallel to Z axis)
■ Plan: default 90°/270° (perpendicular to Z axis)
W: Departure angle (reference: Z axis)
■ Longitudinal: Default 90°/270° (perpendicular to Z axis)
■ Transverse: Default 0°/180° (parallel to Z axis)
X, Z: Cutting limit
Type of oversize is selected by soft key per Softkey
I, K: Different longitudinal/transverse oversize
I: Constant oversize – generates ”oversize G58” before the
cycle
Plunging: Machine descending contours ?
■ Yes
■ No
E: Reduced plunging feed rate with descending contours
H: Type of departure – type of contour smoothing
■ H=0: Smoothing after each cut along the contour
■ H=1: Lift off at under 45°; contour smoothing after the last
cut
■ H=2: Lift off at under 45° – no contour smoothing
Q: Retraction at cycle end
■ Q=0: Return to starting point
Longitudinal: first X, then Z direction
Transverse: First Z, then X direction
■ Q=1: Positions in front of the finished contour
■ Q=2: Lifts off to safety clearance and stops
Undercutting (see soft-key table)
H: Type of departure – type of contour smoothing
■ H=0: Smoothing after each cut along the contour
■ H=1: Lift off at under 45°; contour smoothing after the last
cut
■ H=2: Lift off at under 45° – no contour smoothing
Q: Retraction at cycle end
■ Q=0: Return to starting point
Longitudinal: first X, then Z direction
Transverse: First Z, then X direction
■ Q=1: Positions in front of the finished contour
■ Q=2: Lifts off to safety clearance and stops
Undercutting (see soft-key table)
6.12 Int
er
activ
e
W
o
rking Plan Gener
ation (IWG)