HEIDENHAIN CNC Pilot 4290 - Manual (Page 389)

HEIDENHAIN CNC PILOT 4290 377
8.1.3 Tool Parameters
Parameters for turning tools
Parameters in dialog box 1 G S TP
ID: Identification number of tool • • •
X, Z dim. (xe, ze): Setting dimensions • – –
Tool angle W (ew): Setting angle • • •
Tip angle W (sw): Nose angle • • •
Radius (rs): Cutting radius • • •
NBR: Secondary machining direction • – •
Cut.wd (sb) – Thread tool:
Cutting edge width – distance from the tool edge to the
tool tip
• • –
Cut.wid. (sb): Cutting width • • •
Cut.len.(sl): Cutting length • • •
Cut.lg (sl) – Knurling tool: Roll diameter – • –
RCut.wd (sb) – Knurling tool: Roll diameter – • –
NBR: Secondary machining direction • – •
X, Z comp. (DX, DZ): Compensation values
(maximum value +/– 10 mm)
• – –
Direc.rot.: Direction of spindle rotation • – •
Usab.lg.(nl): Usable length for internal too
ls –
– •
Dep.imm. (et): Maximum infeed depth • • •
3 comp. (DS): Special correction value for the
3rd cutting edge (maximum value +/– 10 mm) –
see also G148 and G150/G151
• – –
Threading tool:
■ Note that for types 141, 143 the ”setting dimension ze”
and for type 142, 144, the ”setting dimension xe” is
measured from the tool edge.
■ The CNC PILOT uses the ”direction of rotation”
parameter to determine whether an overhead tool or a
standard tool is used.
Example: Tool type 111
Continued
8.1 T
ool
D
atabase