HEIDENHAIN CNC Pilot 4290 - Manual (Page 447)

HEIDENHAIN CNC PILOT 4290 435
11
.2
T
e
c
hnical
Inf
or
mation
Programming CNC PILOT 4290
C-axis machining ■ Display and programming in 3 views (ZX, XC, ZC plane), and the
unrolled lateral surface
■ Hole and figure pattern in the XC and ZC plane
■ Machining cycles for drilling and milling on front face and lateral
surface.
Y-axis machining ■ Display and programming in 3 views (ZX, XY, ZY plane), and the unrolled
lateral surface
■ Hole and figure pattern in the XY and ZY plane
■ Machining cycles for drilling and milling in the XY and ZY planes
TURN PLUS – Graphical programming (option)
Programming in individual work steps for the turning axis, C axis, Y axis
and full-surface machining with:
■ Calling tool and cutting data
■ Individual selection and and definition of the machining mode
■ Direct graphic verification of simulated cutting and subsequent
correction possibilities for rear side machining
■ Rechucking with machine-specific expert program for rear-side
machining
■ Interactive generation of the work blocks for rechucking and the
second setup
TURN PLUS – Automatic DIN PLUS program generation (option)
Automatic NC programming for the turning axis, C axis, Y axis and full-
surface machining
■ Automatic tool selection
■ Automatic turret assignment
■ Automatic generation of the machining sequence in all machining
planes
■ Automatic cutting limit by chucking equipment
■ Automatic rechucking with machine-specific expert program for rear-
side machining
■ Automatic generation of work blocks for rechucking and the second
setup
Information system ■ Information on the G functions
■ Support for graphic programming in TURN PLUS
■ Support for interactive programming in TURN PLUS
■ Information on parameters and operating resource data
■ Context-sensitive call of the Info system
■ Topic search in table of contents and subject index