HEIDENHAIN CNC Pilot 4290 - Manual (Page 368)

7 Parameters 356
Set-up parameters (continued)
Datum - Oversize G53/G54/G55
The CNC PILOT manages allowances for zero point
offsets for each slide. ”PgUp/PgDn” switches to the
next/previous slides.
■ Oversize X, Y, Z – Slide 1
■ Oversize X, Y, Z – Slide 2
. . .
Datum shift C-axis
■ Datum shift, C-axis 1
■ Datum shift, C-axis 2
■ Influences the C-axis actual value.
■ The zero point shift G152 is added to this parameter.
Tool life monitoring
■ Tool life switch – tool life/quantity monitoring
■ 0: OFF
■ 1: ON
■ Load monitoring
■ 0: OFF
■ 1: ON
Additive compensation
The CNC PILOT manages 16 compensation values
(for each X and Z). The compensation values can be
activated/deactivated in the NC program (see G149,
G149 Geo).
■ Compensation 901..916 in X
■ Compensation 901..916 in Z
If an additive compensation value is changed in Automatic
mode, this parameter is changed accordingly.
Deletion level/cycle
A deletion level can be assigned a deletion cycle. As a
result, NC blocks containing the specified deletion
level are executed each nth time.
■ Deletion level [0..9]
■ Deletion cycle [0..99]
0: NC blocks with this deletion level are never executed.
1: NC blocks with this deletion level are always executed.
2..99: NC blocks with this deletion level are executed each 2nd to 99th
time.
Activate/deactivate the skip levels in automatic mode.
7.4 Set-Up P
a
ra
met
ers