HEIDENHAIN CNC Pilot 4290 - Manual (Page 43)

HEIDENHAIN CNC PILOT 4290 31
Soft keys
Delete the tool
Take the tool from the ”ID number clipboard”
Delete the tool and place in the ”ID number clipboard”
Edit the tool parameters
Entries in the tool database - sorted by tool typep
Entries in the tool database - sorted by tool ID numberr
Accept the ID number of the ”nominal tool” in the tool
list
3.3 T
ool Lists,
T
ool Lif
e D
a
ta
3.3.2 Comparing a Tool List with an NC
Program
The CNC PILOT compares the current tool list with
the entries in the NC program last translated in
automatic mode.
Comparing a tool list
Select ”Setting up - Tool list - Compare list” The
CNC PILOT shows the current contents of the tool
list and marks deviations from the programmed
tool list.
<
Select marked tool location
<
Nominal-actual comparison
Press ENTER (or INS key). The CNC PILOT opens
the ”nominal-actual comparison” dialog box.
<
Accept the ID number of the ”nominal
tool” in the tool list
or
Look for the tool in the database
The CNC PILOT shows the following tools marked:
■ Actual tool ≠ nominal tool
■ Actual – not occupied; nominal – occupied
The entries in the TURRET section are considered
nominal tools (reference:TURRET section of the NC
program most recently interpreted in Automatic
mode).
Tool locations that are not assigned in the NC
program cannot be selected.
Danger of collision
■ Tool pockets that are occupied but,
according to the NC program, are not
needed, are not marked.
■ The CNC PILOT compensates the tool
actually entered – even if it does not
match the nominal assignment.