HEIDENHAIN CNC Pilot 4290 - Manual (Page 330)

6 TURN PLUS 318
Main machining Submachining Location Execution
Deburring Contour analysis: Determining milling contours with the
attribute ”Deburring.”
Sequence – machining location:
■ Front face (also machines front face in Y)
■ Lateral surface (also machines lateral surface in Y)
– then sequence of geometrical definition
– – Machining all milling contours with the attribute
”Deburring” on all machining locations
Contour, slot,
pocket (*) Location Machining all milling contours with the attribute
”Deburring” on the selected machining location
*: Define the type of contour
Engraving Contour analysis: Determining milling contours with the
attribute ”Engraving.”
Sequence – machining location:
■ Front face (also machines the front face in Y)
■ Lateral surface (also machines the lateral surface in Y)
– then sequence of geometrical definition
– – Machining all milling contours with the attribute
”Engraving” on all machining locations
Contour, slot (*) Location Machining all milling contours with the attribute
”Engraving” on the selected machining location
*: Define the type of contour
Finish-milling Contour analysis: Determining the milling contour.
Sequence – milling operation:
■ Linear and circular slots
■ Open contours
■ Closed contours (pockets), single surfaces and
polygonal surfaces
Sequence – machining location:
■ Front face (also machines front face in Y)
■ Lateral surface (also machines lateral surface in Y)
– then sequence of geometrical definition
– – Execution of all milling operations on all machining
locations
Surface, contour, slot,
pocket (*) – Execution of the selected milling operation on all
machining locations
Continued
6.13 A
u
tomatic W
o
rking Plan Gener
ation (A
WG)