HEIDENHAIN CNC Pilot 4290 - Manual (Page 445)

HEIDENHAIN CNC PILOT 4290 433
11
.2
T
e
c
hnical
Inf
or
mation
11.2 Technical Information
CNC PILOT 4290
Standard features Contouring control with integrated motor control and integrated inverter
■ 2 close-loop axes X1 and Z1 on slide 1
■ 1 close-loop spindle
Expandable To up to 10 closed loops
■ Maximum 6 slides
■ Maximum 4 spindles
■ Maximum 2 C axes
Display 15-inch TFT flat-panel display
Program memory Hard disk
Interpolation
Straight lines In 2 principal axes, optionally in 3 principal axes (maximum ±10 m)
Circular arcs In 2 axes (maximum radius 100 m)
C axis Interpolation of linear axes X and Z with the C axis
Helices Superimposition of circular and linear paths
Look-ahead Preliminary calculation of the contour speed profile
under consideration of up to 20 blocks
Feed rate ■ Maximum input at 0.001 mm resolution: 400 m/min
■ Input in mm/min or mm/revolution
■ Constant cutting speed
■ Feed rate with chip breaking
Data interfaces nÿ RS-232-C/V.24 with up to 38.4 kilobaud
■ Ethernet 100 BaseT (maximum 100 megabaud)
■ Printout over serial interface
Accessories CNC PILOT 4290
DataPilot PC software for programming and training for the CNC PILOT 4290 lathe
control:
■ Programming and Test Run
■ Program management
■ Operating resource data management
■ Data backup
■ Training