HEIDENHAIN CNC Pilot 4290 - Manual (Page 35)

HEIDENHAIN CNC PILOT 4290 23
3.1 S
witc
h-On,
S
witc
h-Of
f,
Ref
er
ence Run
Reference jog (single axis)
Select ”Ref – Reference jog.”
<
”Status of reference run approach” informs you of
the current status. Axes that have not been
referenced are shown in gray.
<
Set slides and axes (”reference jog” dialog box)
<
The reference run is continued as long
as you keep pressing the key. To
interrupt the reference run, release the
key.
Cancels the reference run
<
After completion of the reference run:
■ The position display is active for the axis that has
been referenced.
■ If all axes have been referenced, you can select
automatic mode.
3.1.2 Switch-Off
Switching off the CNC PILOT. Confirm
the subsequent request with OK. The
control is shut down in an orderly
manner. After a few seconds, CNC
PILOT requests you to switch off the
machine.
”Shutdown” is available in the programming and
organization modes if no operating mode is selected.
Proper switch-off is recorded in the error log file.
Exiting the ”Reference jog” dialog box: Press cycle stop
The software limit switches are only active after you
have traversed the reference marks.