HEIDENHAIN CNC Pilot 4290 - Manual (Page 86)

4 DIN PLUS 74
4
.3
The DIN PLUS Edit
or
■ Block numbering: The number ”interval” is specified for the first
NC block; for each following block the ”interval” is added. Block
references in contour-related G commands and subprogram calls
are corrected automatically. The sequence of the NC blocks is
retained.
■ New: free input
Position the cursor.
Select ”New: free input.”
Enter NC block
The new NC block is inserted below the cursor position.
■ Modify: free input
Position the cursor on the NC block to be edited.
Select ”New: modified input.”
Edit the NC block
”Config(uration)” menu group:
■ Aux. pict.:Select whether you wish to display the help graphics.
■ Window – Full-size window/Double window/Triple window:
Select the number of editing windows
■ Font size – smaller/larger: Change the font size within the editing
window
■ Font size – Adjust fonts: Set the font size of the selected window
in all editing windows
■ Settings – Save: Saves the current editor condition (window
setting, all loaded NC programs)
■ Settings – Load: Loads the lasts save condition of the editor
■ Settings – Auto-save on: Saves the current editor condition when
CNC PILOT is switched off
■ Settings – Auto-save off: No saving of the editor condition when
the CNC PILOT is switched off
”Graphics” pull-down menu
■ Graphic ON: activates contour simulation.
■ Graphic - OFF: deactivates contour simulation and activates the
machine display.
■ Window (selection of simulation window): Select a maximum of
two windows. The contour simulation is activated by selecting
”Graphic ON.”