HEIDENHAIN CNC Pilot 4290 - Manual (Page 310)

6 TURN PLUS 298
Transfer parameters in expert program with
other name
”Parting” (see sketch)
Spindle speed limitation (LA) for the parting process
Feed rate reduction (LB): Feed value for the ”last
part” of the parting operation
Jaw rinsing (K): see machine manual
Starting position X (O): For the parting operation –
proposed value: from the workpiece
description
Position for reduced feed X (P): From this position,
traverse is at reduced feed rate
End position X (R): End position during parting
Start position Z (S): For the parting operation –
proposed value: Vertical element from the
”selection”
Parting tool width (Y): Width of the parting tool's
cutting edge
”Workpiece transfer” (see also ” 6.11 Prepare –
Rechuck”)
Angular synchronization (LC):
■ 0: Angular synchronization
■ 1: Speed synchronization
Angular offset (LD): with angular synchronization
Dead stop (LE):
■ 0: With traverse to dead stop
■ 1: Without traverse to dead stop
Machine dimension (LF): Transfer position in machine
dimension n (n: 1..6)
Minimum feed path (LH): For ”traversing to dead
stop” (see machining manual)
Maximum feed path (LH): For ”traversing to dead
stop” (see machining manual)
Incr. feed path (J): For ”traversing to dead stop” (see
machining manual)
Working position Z $2 (U): Working position of
opposed spindle -proposed value: Zero point
offset e.g. from machine parameter 1164 for
Z axis $1 (see sketch)
Zero point shift (W): Shift of the NC zero point
(calculation: distance from reference point on
chuck to dead stop on chuck jaw + finished
part length)
Finished part length (LF): From the workpiece
description
With TURN PLUS (Z):
■ 1: Prepare work on the opposing spindle
(switch-on conversions, zero point shift, etc.)
6.12 Int
er
activ
e
W
o
rking Plan Gener
ation (IWG)