HEIDENHAIN CNC Pilot 4290 - Manual (Page 91)

HEIDENHAIN CNC PILOT 4290 79
4.4 Program Section Codes
A new DIN program is already provided with section
codes. You can add new codes or delete existing
ones, depending on your program requirements. A
DIN program must contain at least the MACHINING
and END section codes.
4.4 Pr
ogr
am Section Codes
Overview of program section codes
PROGRAMMKOPF [PROGRAM HEAD]
TURRET
MAGAZINE
CHUCKING EQUIPMENT
KONTUR [CONTOUR]
ROHTEIL [BLANK]
FERTIGTEIL [FINISHED PART]
HILFSKONTUR [AUXILIARY CONTOUR]
BEARBEITUNG [MACHINING]
ENDE [END]
UNTERPROGRAMM [SUBPROGRAM]
RETURN
Machining with the C axis
FRONT
REAR SIDE
SURFACE
4.4.1 PROGRAMMKOPF [PROGRAM HEAD]
The PROGRAM HEAD comprises:
■ Slides: NC program is run only on the given slides
(input: „$1, $2, ...”) – no input: NC program is run for
every slide.
■ Unit: Unit of measure ”metric/inches” – no input:
The unit of measure defined in control parameter 1
is used
■ The other codes contain organizational
information and set-up information that do not
influence the program run.
Information contained in the program head is
preceded by ”#” in the DIN program.
The ”Unit” can be programmed only when a new program
is being created (set under PROGRAM HEAD). It is not
possible to post-edit this entry.