HEIDENHAIN CNC Pilot 4290 - Manual (Page 49)

HEIDENHAIN CNC PILOT 4290 37
3.4.4 Setting up the ChuckingTable
The chucking table is evaluated by the concurrent
graphics.
Setting up the chucking table
Select ”Setting up – Chucking table – Main spindle
(or Tailstock)
<
Select the ID number from the chucking database
Chucking equipment for spindles
The definition of the clamping form (”Grip. form”)
presupposes the definition of the chuck jaws. Set the
clamp form by soft key – it is graphically illustrated.
To switch to the chucking assignment of further
spindles, press the Page Up/Page Dn keys.
Parameters for ”spindle x” (main spindle, spindle 1, ..)
■ Chucking ID (identification number): Reference to
database.
■ Chuck jaws ID (identification number): Reference to
database.
■ Chuck supplement ID (identification number):
Reference to database.
■ Clamp form (for chuck jaws): Define internal/
external chucking and the level of chuck jaws used
■ Clamping diameter: The diameter at which the
workpiece is clamped. (Workpiece diameter when
clamped externally; inside diameter when internal
clamping is used)
”Tailstock” parameters
■ Sleeve center ID (identification number): Reference
to database.
Soft keys
Edit the chucking equipment parameters
Entries in the chucking database – sorted by chuck type
Entries in the chucking database – sorted by chuck ID
number
”Continue” – Define the clamp form
3.4 Setup Functions