HEIDENHAIN CNC Pilot 4290 - Manual (Page 236)

6 TURN PLUS 224
Defining a contour with basic elements
If required, adjust the reference plane (front face,
lateral surface, etc.)
<
Select ”Workpiece - Finished part - Contour.”
<
Select ”Machining surface” – Check and correct the
”Reference dimension”
<
Define the ”Starting point of the contour”
<
Describe the C/Y contour element for element
<
After the contour has been completed, press the
ESC key twice.
Define pattern/single hole
Select ”Workpiece - Finished part - Pattern.”
<
Select pattern/single hole.
<
If required, adjust the reference plane (front face, lateral surface,
etc.)
<
Select ”Machining surface” – Check and correct the ”Reference
dimension”
<
Patterns
■ Enter pattern positions and data
■ Select the Hole/Figure soft key and define the hole/figure
Single hole
■ Enter the position
■ Press the ”hole” button and define the hole
Check your entries; Press OK.
6
.3
W
o
rkpiece Descr
iption
Defining figures
Select ”Workpiece – Finished part – Figure”
<
Select the figure type
<
If required, adjust the reference plane (front face, lateral surface,
etc.)
<
Select ”Machining surface” – Check and correct the ”Reference
dimension”
<
■ Enter the position
■ Press the ”figure” button and define the figure
<
Check your entries; Press OK.