HEIDENHAIN CNC Pilot 4290 - Manual (Page 362)

7 Parameters 350
Control parameters (continued)
22 – Simulation: Default window size (X, Z)
The simulation function adapts the window size to the
workpiece blank. If no blank part is programmed, the
CNC PILOT uses a standard window size.
Evaluation: Simulation mode
■ÿ Zero position X – Distance of the origin of the coordinate system
from the lower window frame
■ÿ Zero position Z – Distance of the origin of the coordinate system from
the left window frame
■ÿ Delta X – Vertical expansion of the graphics window
■ÿ Delta Z – Horizontal expansion of the graphics window
23 – Simulation: Default blank
If no blank part is programmed, the CNC PILOT uses
a standard blank.
Evaluation: Simulation mode
■ÿ Outside diameter
■ÿ Length of blank part
■ÿ Right edge of blank part(Allowance) reference: Workpiece zero point
■ÿ Inside diameter for hollow cylinders, solid blanks: 0
24 – Simulation: Color table for feed lengths
The feed travel of a tool is displayed in the color
assigned to the respective turret location.
Evaluation: Simulation mode
■ÿ Color for turret position n (n: 1..16) – color code:
■ÿ 0: light green (default color)
■ÿ 1: dark gray
■ÿ 2: light gray
■ÿ 3: dark blue
■ÿ 4: light blue
■ÿ 5: dark green
■ÿ 6: light green
■ÿ 7: dark red
■ÿ 8: light red
■ÿ 9: yellow
■ 10: white
27 – Simulation: Settings
The machining simulation and the control graphics
(TURN PLUS) are delayed by the ”path delay” time
after each path that has been simulated graphically.
The simulation speed can thus be influenced.
Smallest unit: 10 msec
Evaluation: Simulation mode
■ÿ Path delay (machining)
7.3 Contr
ol P
a
ra
met
ers