HEIDENHAIN CNC Pilot 4290 - Manual (Page 352)

7 Parameters 340
7.1 P
a
ra
met
er Mode of Oper
ation
■ The CNC PILOT checks whether the user is authorized to
change a parameter. Log on as system manager if you
wish to edit protected parameters. Otherwise, you are
only authorized to read parameters.
■ Parameters that influence the production of a workpiece
cannot be edited in automatic mode.
■ Parameters that you as machine operator cannot change
are explained in the Technical Manual.
Editing configuration parameters
You edit parameters of the ”machine” and ”control”
groups as follows:
Editing parameters
Log on as system manager (Service mode)
<
Select ”config” (Parameter mode)
<
Parameter number unknown:
Select parameter group (machine, control)
<
Select parameter (”arrow up/down” or touch pad)
<
ENTER – the CNC PILOT presents the parameter
for editing
Parameter number is known:
”Machine direct / Control direct”
<
Enter the parameter number
<
Make the changes
In the submenu of ”Config” you can select in addition
the parameter groups
■ Setup parameters
■ Machining parameters
■ PLC parameters
The procedure is identical with that described under
parameters lists.