HEIDENHAIN CNC Pilot 4290 - Manual (Page 361)

HEIDENHAIN CNC PILOT 4290 349
7.3 Contr
ol P
a
ra
met
ers
Control parameters (continued)
■ÿ Measuring mode
■ÿ 1: Post-process measuring
■ÿ Measured-value coupling
■ÿ 0: New measured values overwrite old measured values.
■ÿ 1: New measured values are not accepted until old measured values
are evaluated.
In control parameters 40, ..., the serial interface is selected
and the interface parameters are defined.
11 – FTP parameters
Evaluation: Data transfer using FTP (file transfer protocol)
■ÿ User name: Name of one's own station
■ÿ Password
■ÿ Address/name of FTP server: Address/name of remote station
■ÿ Use FTP
■ÿ 0: No
■ÿ 1: Yes
The parameters can also be set using the transfer functions.
20 – Time determination for simulation: general
Non-cutting time for the ”time counting” function.
Evaluation: Time counting (Simulation mode)
■ÿ Tool change time [sec]
■ÿ Gear shifting time [sec]
■ÿ Time allowance for M functions [sec]: All M functions are rated with
this time. If an M function is also specified in control parameter 21, the
time allowances entered here are added.
21 – Time determination for simulation: M
function
Individual time allowances for a maximum of 10 M
functions.
Evaluation: Time calculation (Simulation mode)
■ÿ 1..10. M function – Number of the respective M function
■ÿ Time allowance [sec] – individual time allowance. The time calculation
function in simulation mode adds the specified time to the time
allowance entered in control parameter 20.