HEIDENHAIN CNC Pilot 4290 - Manual (Page 332)

6 TURN PLUS 320
Editing and managing machining
sequences
Editing a machining sequence
Select ”AWG - Machining order - Change”; TURN
PLUS opens the machining sequence editor.
<
Select the position
<
Entering a new machining sequence
■ Position the cursor (the new code is inserted in
front of the cursor position)
Activates the ”Enter the machining
sequence” dialog. Select
■ Main machining
■ Submachining
■ Location
and confirm with ”Enter.”
”OK” confirms the new machining sequence
Editing the machining sequence
■ Position the cursor
Activates the ”Enter the machining
sequence” dialog. Select
■ Main machining
■ Submachining
■ Location
and correct it with ”Enter.”
”OK” confirms the edited machining sequence
Deleting a machining operation
■ Position the cursor
TURN PLUS removes the NC code
<
”OK” saves the changes machining sequence
6.13 A
u
tomatic W
o
rking Plan Gener
ation (A
WG)
Managing the machining sequence files
The following subpoints of ”AWG – Machining sequence” help you
manage the files:
■ Load
■ Saving (storing on hard disk)
■ Delete