HEIDENHAIN CNC Pilot 4290 - Manual (Page 126)

4 DIN PLUS 114
The actual value display shows the feed
rate in mm/rev.
G26/Gx26 limits the spindle speed.
4.6 Machining Commands
Feed per tooth Gx93
Drive-dependent feed rate with respect to the number of teeth on the
milling cutter (x: spindle 1...3).
Parameters
F:
Feed per tooth (mm/tooth or inch/tooth)
Constant feed G94 (feed per minute)
Drive-independent feed rate.
Parameters
F:
Feed per minute (mm/min / inch/min)
Feed per revolution Gx95
G95: Spindle; Gx95: Spindle x (x: 1...3)
Drive-dependent feed rate.
Parameters
F:
Feed per revolution (mm/rev / inch/rev)
Constant cutting speed Gx96
G96: Spindle; Gx96: Spindle x (x: 1...3)
The spindle speed is dependent on the X position of the tool tip or on
the diameter of the driven tools.
Parameters
S:
Cutting velocity (in m/min or ft/min)
Speed Gx97
G97: Spindle; Gx97: Spindle x (x: 1...3)
Constant spindle speed.
Parameters
S:
Speed (in revolutions per minute)