HEIDENHAIN CNC Pilot 4290 - Manual (Page 382)

7 Parameters 370
7.5 Mac
hining P
a
ra
met
ers
12..19 – Load monitoring for
machining modes (continued)
■ 12 Load monitoring, centric predrilling
■ Drilling, centric ON/OFF
■ Centering
■ Drilling
■ Counterboring
■ Countersinking
■ Reaming
■ Tapping
■ 13 Load monitoring, roughing
■ Roughing ON/OFF
■ External, longitudinal
■ External, transverse
■ Internal, longitudinal
■ Internal, transverse
■ 14 Load monitoring, contour recessing
■ Piercing ON/OFF
■ External
■ Internal
■ Transverse
■ 15 Load monitoring, contour machining
■ Finishing ON/OFF
■ External
■ Internal
■ 16 Load monitoring, recessing
■ Recessing ON/OFF
■ External
■ Internal
■ 17 Load monitoring, thread cutting
■ Thread cutting ON/OFF
■ External
■ Internal
■ Transverse
■ 18 Load monitoring, drilling C-axis
■ Drilling, C-axis ON/OFF
■ Centering
■ Drilling
■ Counterboring
■ Countersinking
■ Reaming
■ Tapping
■ 19 Load monitoring, milling C-axis
■ Milling ON/OFF
■ Slot milling
■ Contour milling
■ Pocket milling
■ Deburring
■ Engraving
20 – Direction of rotation for rear-side machining
■ Mirror direction of rotation
■ 0: Direction of spindle rotation remains the same for front
and rear side
■ 1: Direction of spindle rotation is mirrored, i.e. M3
becomes M4 and vice versa)
21 – Name of the subroutines
TURN PLUS uses expert programs for functions such as
workpiece transfer for full-surface machining. This parameter
defines which expert programs (subroutines) are used.
Enter the subprogram names.
■ UP 100098 (parting)
■ UP 100099 (bar loader)
■ UP EXUMS12 (currently no meaning)
■ UP EXUMS12A (currently no meaning)
■ UP MEAS01 (measuring cut)
■ UP UMKOMPL (rechucking for lathes with
counterspindle)
■ UP UMKOMPLA (parting and rechucking for lathes with
counterspindle)
■ UP UMHAND (rechucking for lathes without
counterspindle)
■ UP ABHAND (parting and rechucking on machines
without opposing spindle)