Kawasaki D Series Controller MPVDCONTV113E-3 - Manual (Page 129)

TROUBLESHOOTING
D SERIES CONTROLLER
TROUBLESHOOTING AND COMPONENT REPLACEMENT
1-126 August 9, 2005
Ka a a w s k
ERROR CODE E4501 ANYBUS) OUT/FB.CTRL release timeout. XX
Access to the input signal reading area is not released due to defective hardware.
⇒
Check LED indicator on the interface card, and reset the error.
⇒
If the error message is still displayed contact KRI customer service, include the sub-
code XX.
_____________________________________________________________________
ERROR CODE E4510 DN) Master status. XX
The status of the master port changed due to faulty communication, caused by cable
disconnection during DeviceNet communication. XX indicates the status code.
⇒
Check the status sub-code XX and reset the error.
_____________________________________________________________________
ERROR CODE E4511 DN) Node status. XX
The status of the slave node changed due to faulty I/O communication, caused by
DeviceNet slave node cable disconnection.
⇒
Use the status sub-code XX as a troubleshooting aid .
⇒
Check the DeviceNet slave node cable and connections, and repair as necessary.
_____________________________________________________________________
ERROR CODE E4512 ABM-DN) Mailbox error.
An error is returned because data sent the mailbox is not accepted due to incorrect
DeviceNet parameter setting.
⇒
Ensure the MAC_ID specified for the slave node and the parameter settings are
correct, and re-execute DEVNET command
.
_____________________________________________________________________
ERROR CODE E4520 ABMA-PDP) Status STOP. XX
During I/O communication in auto clear mode, an error occurred in the slave node and
the status of AnyBus PROFIBUS-DP master changed to STOP.
⇒
Check the connections of the fieldbus cable and repair as necessary .
⇒
Use the sub-code XX as a troubleshooting aid, clear the cause of the error and reset
the error.
_____________________________________________________________________