9 replacement procedure for fuses, 1 fuses on 1kp board – Kawasaki D Series Controller MPVDCONTV113E-3 User Manual
Page 257
Advertising
D SERIES CONTROLLER
TROUBLESHOOTING AND COMPONENT REPLACEMENT
2-28
Ka a a
w s k
2.9
REPLACEMENT PROCEDURE FOR FUSES
This section describes the replacement procedure for the fuses.
2.9.1 FUSES ON 1KP BOARD
Two types of fuses- Fuse1 and Fuse2- are mounted on the 1KP board.
1. Turn OFF the control power.
2. Push the fuse on the front of the board and turn it 90 degrees to the left. Then pull it out
and remove the fuse from the board.
3. Push in the new fuse, and turn it 90 degrees to the right to install.
Overview of the 1KP board
Fuse1 (E-Stop: 315 mA)
Fuse2 (Machine valves: 1A)
Advertising