Omron SYSMAC CJ1W-EIP21 - Manual (Page 20)

xx
Note The unit version will be displayed in the Unit Manufacturing Information Dialog
Box.
Using Unit Version Label The following unit version label is provided with the EtherNet/IP Unit.
This label can be attached to the front of the EtherNet/IP Unit to differentiate
between EtherNet/IP Units with different unit versions.
Unit Versions and CX-Programmer Versions
Use the following versions of the CX-Programmer to make the Unit settings for
the EtherNet/IP Unit.
* The following auto update must be applied to use CX-Programmer version 8.0:
CX-Common Components/CPS Upgrade Software 2008.08 0302
Unit Version Notation In this manual, the unit version of a EtherNet/IP Unit is given as shown in the
following table.
Note Some Support Software products call the EtherNet/IP Unit version the “revi-
sion.” “Revision” is also sometimes used in this manual.
CIP Revisions and
Unit Versions The CIP revisions corresponding to the unit versions of the EtherNet/IP Unit
are given in the following table.
Unit version
Unit version CX-Programmer
Ver. 7.1 or lower Ver. 8.0 Ver. 8.02 or higher
Unit version 1.0 --- OK* OK
Unit version 2.0 --- OK OK
Product nameplate Notation used in this manual Special remarks
Ver. 1.0 or later number
shown to right of the lot
number Ethernet Unit Ver. 1.0 or later (See note.) Information without reference to specific Unit
Versions applies to all versions of the Unit.
Unit version CIP revision
Version 1.0 Revision 1.01
Version 2.0 Revision 2.01 or 2.02