Ip address write, Response codes, Command block response block parameters – Omron SYSMAC CJ1W-EIP21 User Manual
Page 430: Ip address (command), Subnet mask (command)
404
FINS Commands Addressed to EtherNet/IP Units or Built-in EtherNet/IP Ports
Appendix E
• An error response will be returned if the IP address conversion method in the system mode settings is set
for automatic generation on the FINS/UDP Tab Page of the Unit.
Response Codes
IP ADDRESS WRITE
Write the local IP address and the subnet mask in the CPU Bus Unit System Setup.
Command Block
Response Block
Parameters
IP Address (Command)
Specify the local IP address of the EtherNet/IP Unit or built-in EtherNet/IP port using 4 pairs of 2-digit hexadec-
imal numbers in the range 00.00.00.00 to FF.FF.FF.FF (0.0.0.0 to 255.255.255.255 decimal). Specify 0.0.0.0 to
enable the local IP address set in the allocated DM Area words.
Example: 150.31.2.83
Subnet Mask (Command)
Specify the local IP address of the EtherNet/IP Unit or built-in EtherNet/IP port using 4 pairs of hexadecimal
numbers in the range 00.00.00.00 to FF.FF.FF.FF (0.0.0.0. to 255.255.255.255 decimal).
Example: 255.255.255.255
Response code
Description
0000
Normal end (echo reply received from the remote node)
1001
Command too large
1002
Command too small
1003
The number of records specified does not match the sent data
length.
110C
The number of records is not between 0 and 32.
The FINS node address is not between 1 and 126
The IP address is 0.
2307
IP address conversion method is set for automatic generation.
27 57
Subnet mask
IP address
Command
code
27 57
Command
code
Response
code
96
53
1F
02
FF
00
FF FF