Freescale Semiconductor StarCore SC140 - Manual (Page 114)

4-4 SC140 DSP Core Reference Manual
Overview of the Combined JTAG and EOnCE Interface
Figure 4-2 shows the TAP controller state machine, and Table 4-3 shows the states associated with each
scan path. The Test Mode Select
(TMS ) pin determines whether an instruction register scan or a data
register scan is performed.
0 0 1 0 0 HIGHZ Selects the Bypass Register. Disables all device output drivers
and forces the output to high impedance (tri-state) as per the
IEEE specification.
0 0 1 1 0 ENABLE_EONCE Selects the EOnCE registers. Allows to perform system debug
functions. Before this instruction is selected, the
CHOOSE_EONCE instruction should be activated to define
which EOnCE is going to be activated.
0 0 1 1 1 DEBUG_REQUEST Selects the EOnCE registers. Forces the chosen cores EOnCE
modules into Debug state or generate a Debug exception. Before
this instruction, the ENABLE_EONCE and the
CHOOSE_EONCE instructions should be performed.
0 1 0 0 0 RUNBIST Selects the BIST registers. Allows you to generate a built-in
self-test for checking the system circuitry.
0 1 0 0 1 CHOOSE_EONCE Selects the EOnCE registers. Allows to select EOnCE targets in
devices with multiple EOnCE modules. This instruction is
activated before the ENABLE_EONCE and
DEBUG_REQUEST instructions.
0 1 1 0 0 ENABLE_SCAN Selects the DFT registers. Allows the DFT chain registers to be
loaded by a known value or examined in the Shift_DR controller
state.
0 1 1 0 1 LOAD_GPR Allows the component manufacturer to gain access to test
features of the device.
0 1 1 1 0 LOAD_SPR Allows the component manufacturer to gain access to test
features of the device.
1 1 1 1 1 BYPASS Selects the Bypass register. Creates a shift register path from TDI
to the Bypass Register and to TDO. Enhances test efficiency
when a component other than the current device becomes the
device under test.
Table 4-2. JTAG Instructions (Continued)
B4 B3 B2 B1 B0 Instruction Description