Leica Biosystems PELORIS_PELORIS II - Manual (Page 53)

Running Protocols
Leica PELORIS™ User Manual Rev K © Leica Biosystems Melbourne Pty Ltd 2011 53
3.4.2 Editing the Protocol for a Single Run
You can edit the protocol for an individual run just before the run is started. You can make two
types of change:
1. Skip the first steps of the protocol
2. Change step durations
Make both types of change in the Edit protocol instance dialog box opened from the
Scheduling dialog box. Start a protocol run as normal from the Status screen and continue until
the Scheduling dialog box opens. Tap the Edit steps button to open the Edit protocol instance
dialog box.
Figure 33. Edit protocol instance dialog box

To skip protocol steps tap the step that you want to start the run with. Steps prior to this are
unchecked to show they will not run.
The reagent selected as the new first step will be used for an initial fill if required (see 3.6.1
Delayed End Times and Initial Fills).

To change a step time tap the current step time. Set a new time in the Duration dialog box.
Skipping steps and changing step durations will affect protocol scheduling – confirm that the new
Predicted end time shown in the Scheduling dialog box is acceptable before you start the run.
No check in the circle shows
this step will be skipped
Tap the step that will be the
first to run in the protocol
Tap on a step time to open
the Duration dialog box to
set a new step duration