Leica Biosystems PELORIS_PELORIS II - Manual (Page 83)

Reagent Setup
Leica PELORIS™ User Manual Rev K © Leica Biosystems Melbourne Pty Ltd 2011 83
5.2.3 Managing the Reagent Types Lists
Apart from editing the properties of active reagents and moving them to the dormant list, all
management of the reagent types lists uses the Add reagents dialog box (Figure 46) opened from
the Reagent types screen. The dialog box lists all reagent types, ordered by reagent group, on
the left. Filter the list by reagent group with buttons on the right.
Figure 46. Add reagent dialog box
To add reagent types to the active list select a reagent type from the list and tap the Add reagent
button.
To add a new reagent type to the dormant list tap the Create reagent button. Choose a reagent
group for the new reagent type and then set a unique name for it.
Use the Delete button to remove user defined reagent types from the dormant list. This deletes
them from the software completely. You cannot delete pre-defined reagent types.
Selected reagent type:
tap button to select
Reagent group filters: tap to
show just the reagent types
(in the left of the dialog box)
in the selected groups
Complete list of reagent types
filtered by reagent group
(with buttons at right)
Create reagent: create a
new reagent to add to the
dormant list
Delete: Delete the selected
reagent type (user defined
protocols only)
Add reagent: transfer the
selected reagent type from
the dormant to the active list